Golight HELIOS Thermal Imaging Camera Manuel d'utilisateur télécharger pdf (Page 14)

Mounting & Electrical Installation for Cameras with

Hard-Wired Remote Controls

Determine the location for the system on your vehicle or boat. Locate the

down arrow on the base of the camera; this is to face forward and orient the

camera for full rotation. The camera will rotate 190˚ to the left and right. Cen-

ter the mounting plate with the vise screw on the mounting plate to the back.

Mark the hole locations for the three mounting screws and drill a pilot hole

for each with a 1/8 inch bit. Prior to mounting the plate, note the center of the

plate and draw a circle for the wiring hole.

Wired toggle systems will require a 3/4” hole to accommodate the power &

video wiring.

Fasten the stainless steel mounting plate with the included mounting screws;

3 ea. #10-16x3/4 type AB cross recessed pan head tapping screws. Finish the

installation with silicone sealant in each screw hole before tightening down

the mounting plate. Install the provided grommet in the ¾” hole. Bring the

power and video control cords through the grommet allowing for 1” of slack

under the light. It is suggested that the grommet hole is then sealed with a

marine grade silicone sealant to prevent leakage.

Note: Manufacturer is not liable for any leakage due to installation of the

Helios.

Install the in-dash remote control using the mounting holes in the remote

assembly. The mounting holes are exposed by removing the rubber molded

cover from the remote assembly. A 2” diameter hole needs to be drilled to

accommodate the remote control. A 3” minimum depth will be required to ac-

commodate the remote control and wiring. Place the remote in the hole and

use the four mounting holes as guides for pilot holes for the included screws.

The arrow under the rubber cover should be pointed up for proper installa-

tion. Do not screw the remote control into the dash until the electrical system

installation has been performed and tested.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Golight HELIOS Thermal Imaging Camera Manuel d'utilisateur Page 14